Mitsubishi NZ2GF2B-60DA4 User Manual page 148

(10)Alert output setting (address: 0105
The alert output enable/disable status is set for each channel.
(a) Enabling the setting
Turn on and off Initial data setting request flag (RY9).
(b) Default value
The default value is set to Disable (1) for all channels.
(11)CH Alert output upper limit value (address: 0106
CH Alert output lower limit value (address: 0107
The upper and lower limit values of the alert output range are set.
For details on the alert output function, refer to the following.
• Alert Output Function (
(a) Setting range
• Setting range: -32768 to 32767
• The value to be set must satisfy the condition of Alert output upper limit value > Alert output lower limit
value. An error occurs in a channel for which the setting not satisfying the condition is set. The error code
(062
H
• If the scaling function or shift functions is used, an alert target is the digital value where the operation of
each function is reflected. Set the digital value considering the operation result of the function.
• If Disable (1) is set to Alert output setting (address: 0105
value (address: 0106
0109 , 010B
H
(b) Enabling the setting
Turn on and off Initial data setting request flag (RY9).
(c) Default value
The default value is set to 0 for all channels.
Because the default value is set to 0, change the setting value when using the alert output function.
146
b15 b14 b13 b12 b11 b10 b9 b8
0 0 0 0 0 0
Data for b4 to b15 are fixed to "0".
Page 92, Section 8.9)
) is stored in Latest error code (RWr0), Error flag (RXA) turns on, and the ERR. LED turns on.
, 0108 , 010A
H H
, 010D ) are ignored.
H H
)
H
b7 b6 b5 b4 b3
0 0 0 0 0 0
CH4
), the settings of CH
H
, 010C ) and CH Alert output lower limit value (address: 0107
H H
b2 b1 b0
CH3 CH2 CH1
0: Enable
1: Disable
, 0108 , 010A , 010C
H H H
, 0109 , 010B , 010D
H H H
Alert output upper limit
),
H
)
H
,
H