Mitsubishi NZ2GF2B-60DA4 User Manual page 152

(a) Initializing the parameter area
The parameters stored in a nonvolatile memory are set back to their default values when Commanded (1) is set
in this area.
Parameter of nonvolatile memory
Parameter area initialization command
(address: 1002
Parameter area initialization completed
(address: 1003
(b) Default value
The default value is set to Not commanded (0).
Even if Parameter area initialization command (address: 1002
cleared.
• Warning flag (RX7)
• Error flag (RXA)
• Alert output signal (RX1E)
In addition, Remote READY (RXB) does not turn on.
After Parameter area initialization command (address: 1002
turning off and on the module.
(18)Parameter area initialization completed (address: 1003
This remote buffer memory shows the clear completed status of the parameter stored in the nonvolatile memory.
b15 b14 b13 b12 b11 b10 b9 b8
(a) Initializing the parameter area
When the parameters stored in a nonvolatile memory are set back to their default values, the value in this area
changes to Completed (1). For the on and off timing, refer to the following.
• Parameter area initialization command (address: 1002
(b) Default value
The default value is set to Not performed (0).
150
)
H
)
H
0 0 0 0 0 0 0
Data for b1 to b15 are fixed to "0".
Controlled by the D/A converter module
Controlled by the program
Set parameter
Not
Commanded (1)
commanded (0)
Not performed (0)
) is executed, the following remote input signals are not
H
) is performed, the D/A converter module operates normally by
H
b7 b6 b5 b4 b3
0 0 0 0 0 0
) (
H
Default value
Not
commanded (0)
Completed Not
(1) performed (0)
)
H
b2 b1 b0
0 0
0: Not performed
1: Completed
Page 149, Appendix 3 (17))