● When using the extension module, also set the parameter of the extension module.
For the parameter of the extension module, refer to the following.
Manual for the extension module used
● Set all the items for the parameter. If any blank exists, the parameter cannot be written to the D/A converter module.
● To read the parameter from the D/A converter module, set "Parameter read" for "Method selection" and click the
button.
● The parameter is checked when it is written to the D/A converter module. When the following message is displayed
during the writing, take corrective action for the error code in < >. (
CHAPTER 7 VARIOUS SETTINGS
Page 119, Section 11.2)
7
67