Appendix 1.2 Remote Output Signals - Mitsubishi NZ2GF2B-60DA4 User Manual

Appendix 1.2
(1) Initial data setting request flag (RY9)
Turn on this signal after writing parameter data to the remote buffer memory.
Initial data setting completed flag (RX9) turns on when the operating condition is changed.
For the on and off timing, refer to the following.
• Initial data setting completed flag (RX9) (
(2) Error clear request flag (RYA)
This signal is used to clear Error flag (RXA) and Latest error code (RWr0).
(a) When a moderate error occurs
When this signal is turned on after the cause of the error is eliminated, the error status is cleared and Error flag
(RXA) turns off.
If the signal is turned off before Error flag (RXA) turns off, Error flag (RXA) cannot be turned off.
For the on and off timing, refer to the following.
• Error flag (RXA) (
(b) When a major error occurs
Error flag (RXA) cannot be turned off even if this signal is turned on and off.
For the on and off timing, refer to the following.
• Error flag (RXA) (
(3) CH Output enable/disable flag (RY10 to RY13)
Set whether to output the D/A conversion value or the offset value for each channel.
ON: D/A conversion value
OFF: Offset value
(a) D/A conversion speed
Regardless of turning on this signal, 100µs × the number of conversion enabled channels is applied.
(4) Alert output clear request flag (RY1E)
Turn on and off this signal to clear an alert output.
For the on and off timing, refer to the following.
• Alert output signal (RX1E) (
(5) External power supply monitor request flag (RY1F)
Turn on this flag to activate the external power supply monitoring function.
For the on and off timing, refer to the following.
• External power supply monitor state flag (RX1F) (
Remote output signals
Page 132, Appendix 1.1 (2))
Page 133, Appendix 1.1 (3))
Page 133, Appendix 1.1 (3))
Page 134, Appendix 1.1 (5))
Page 134, Appendix 1.1 (6))
APPENDICES
A
135