Mitsubishi NZ2GF2B-60DA4 User Manual page 145

(4) Cyclic data update watch time setting (address: 0007
This signal is used to set the time to monitor the data update interval of the cyclic transmission (watch time).
When the cyclic transmission remains stopped longer than the cyclic data update watch time, the D/A converter
module is regarded as disconnected from data link and the output status is held or cleared by Digital output
HOLD/CLEAR setting (address: 0011
For Digital output HOLD/CLEAR setting (address: 0011
• Digital output HOLD/CLEAR setting (address: 0011
For Analog output HOLD/CLEAR setting (address: 0104
• Analog output HOLD/CLEAR setting (address: 0104
(a) Setting range
Setting range is 0 (Not monitor) or 1 to 20 (0.1 to 2 seconds). Set the value in increments of 1 (100ms).
(b) Enabling the setting
Turn on and off Initial data setting request flag (RY9).
(c) Default value
The default value is set to Not monitor (0).
If a value out of the setting range is set, the error code (0930
on, and the ERR. LED turns on. Then the I/O operation stops.
(5) Input response time setting (address: 0010
The input response time of the extension input module is set.
Input response time
(a) Enabling the setting
Turn on and off Initial data setting request flag (RY9).
(b) Default value
The default value is set to 10ms (5
● If data other than the above is set, an error occurs. The error code (1F40
flag (RXA) turns on, and the ERR. LED turns on.
● If no extension input module is connected, the setting in this area is ignored.
) and Analog output HOLD/CLEAR setting (address: 0104
H
1.0ms
1.5ms
5ms
10ms
20ms
70ms
).
H
)
H
), refer to the following.
H
) ( Page 144, Appendix 3 (6))
H
), refer to the following.
H
) ( Page 145, Appendix 3 (9))
H
) is stored in Latest error code (RWr0), Error flag (RXA) turns
H
)
H
Setting value
2
3
4
5
6
7
) is stored in Latest error code (RWr0), Error
H
APPENDICES
).
H
H
H
H
H
H
H
143
A