Mitsubishi NZ2GF2B-60DA4 User Manual page 151

(15)Error history clear command (address: 1000
This command is used to clear the error history stored in the nonvolatile memory.
b15 b14 b13 b12 b11 b10 b9 b8
0 0 0
(a) Clearing the error history
The error history is cleared when Commanded (1) is set to this area.
Stored condition of an error history
Error history clear command
(address: 1000 )
H
Error history clear completed
(address: 1001 )
H
(b) Default value
The default value is set to Not commanded (0).
(16)Error history clear completed (address: 1001
This remote buffer memory shows the error history clear completed status stored in the nonvolatile memory.
b15 b14 b13 b12 b11 b10 b9 b8
0 0
(a) Clearing the error history
When the error history is cleared, the value in this area changes to Completed (1).
For the on and off timing, refer to the following.
• Error history clear command (address: 1000
(b) Default value
The default value is set to Not performed (0).
(17)Parameter area initialization command (address: 1002
This command is used to clear the parameter stored in the nonvolatile memory.
The module can be restored using this command when Nonvolatile memory data error (parameter) (error code:
0130 ) occurs.
H
b15 b14 b13 b12 b11 b10 b9 b8
0 0 0
b7 b6 b5 b4 b3
0 0 0 0 0 0
Data for b1 to b15 are fixed to "0".
Controlled by the D/A converter module
Controlled by the program
An error history is stored.
Not
commanded (0)
Not performed (0)
b7 b6 b5 b4 b3
0 0 0 0 0 0 0
Data for b1 to b15 are fixed to "0".
H
b7 b6 b5 b4 b3
0 0 0 0 0 0
Data for b1 to b15 are fixed to "0".
)
H
b2 b1 b0
0 0 0 0 0 0
0: Not commanded
1: Commanded
An error history is not stored.
Commanded (1)
commanded (0)
Completed
(1)
)
H
b2 b1 b0
0 0 0 0 0 0
0: Not performed
1: Completed
) ( Page 149, Appendix 3 (15))
)
H
b2 b1 b0
0 0 0 0 0 0
0: Not commanded
1: Commanded
APPENDICES
Not
Not
performed (0)
149
A