Table of Contents
Advertisement
8.
Set the refresh parameter. Change the value as necessary.
9.
Write the set parameter to the CPU module of the master station and reset the CPU module.
10.
Change the status of the CPU module of the master station to RUN.
11.
The network configuration setting is now completed.
Set the module parameter of the slave station referring to procedure 4 or later in the following section.
Parameter Setting (
For the network configuration, match the settings in GX Works2 and the CPU module before setting the module parameter of
the slave station. When they are not matched, the module parameter of the slave station cannot be written to the slave
station.
RESET
RUN
Page 63, Section 7.1)
CHAPTER 7 VARIOUS SETTINGS
69
7
Advertisement
Table of Contents
Troubleshooting
