Switching On - HBM FS22 SI User Manual

Operation
Status LED
Blinking 2 Hz
ON(0s)
Status LED
Blinking 2 Hz
18
Important
The interrogator default network configuration is
"10.0.0.10:255.0.0.0:0.0.0.0".
3.3

Switching On

Pressing the ON/OFF button will start the interrogator.
The STATUS LED will start blinking at 2 Hz. After
approximately 30 seconds it will start blinking at 1 Hz.
This means that the interrogator is already on and
responsive, but the optoelectronic module is still warming
up. After approximately 90 seconds it should stay on per­
manently. This means that the interrogator is able to
measure.
Status LED
Blinking 1 Hz
~10s >30s
(initialization issues)
Status LED
Blinking 1 Hz
Information
If the interrogator does not start correctly, the STATUS
LED will blink faster. If this happens please contact HBM
FiberSensing technical support.
A4249-8.0 HBM: public
<90s
Status LED
Blinking 5 Hz
Status LED
On
?s
Status LED
Blinking 5 Hz
(measurement issues)
FS22 SI