HBM FS22 SI User Manual page 112

BraggMONITOR SI User Interface
112
Change IP Address
To change the IP address of the interrogator, you must
be connected and access the Configuration tab. To
check if the status is connected please refer to the con­
nection status message displayed on the left of the Gen­
eral Bar. Press the change IP button to pop-up the
change IP Address interface (see Fig. 7.35).
Fig. 7.35
Define the new IP Address (number
Subnet Mask (number
defined according to the IP Address. The Gateway is
0.0.0.0 by default and is user changeable (number
Fig. 7.35). Then, press the Change IP button (number
in Fig. 7.35). The following procedure and status mes­
sages will be shown:
1. Interrogator is restarting. This can take more than a
minute. Please wait.
2. Ping to interrogator is successful. Please wait.
3. Interrogator is ready.
After this process is complete, the connection will be
established with the new IP.
A4249-8.0 HBM: public
2 in Fig. 7.35). The
3 in Fig. 7.35) will be automatically
4 in
1
FS22 SI