Operation
24
3.5.2
Resetting the IP Address of the Interrogator
If for any chance there is the need to physically change
the IP address of the interrogator, there is a reset proce
dure that consists on pressing the ON/OFF button for
more than 10 seconds.
When the button is being pressed for 10 seconds the
POWER LED blinks 3 times and goes OFF. At this
moment the ON/OFF button can be released and the
reset of IP address will happen.
POWER LED
blinking at 1 Hz
Fig. 3.8
This procedure resets the interrogator changing its IP
address to the default and its measuring settings to the
last stored.
Information
The interrogator default network properties are
"10.0.0.10:255.0.0.0:0.0.0.0".
A4249-8.0 HBM: public
POWER LED
POWER LED
ON
blinks 3 times
and goes OFF
FS22 SI