Starting Up; Switching On - HBM DMP41 Operating Manual

5

Starting up

Back of device
Front of device
DMP41
This Chapter shows you the steps that need to be taken to operate your
measurement chain (DMP41 and transducer).
After connecting the transducer (Chapter 4 "Electrical connections") and the
initial start-up described below, you will be able to discover the further
functions and options of the DMP41.
5.1

Switching on

Important
è
Please comply with Chapter 1 "Safety instructions", Page 7!
► Connect your transducer to the relevant socket on the back of the
DMP41.
If you are using a cable pre-assembled in-house, please note the pin
assignments for your transducer in
"Transducer connection", Page 26.
► Connect the DMP41 to the mains with themains cable provided.
The DMP41 power supply is designed for a 115/230 V connection. The
voltage is automatically adapted to the existing mains voltage.
► Switch the DMP41 on using the POWER button on the front of the device
(the launch display appears immediately).
The DMP41 is initialized and detects the existing components. This
procedure takes approx. 45 seconds (the LED above the switch-on
button flashes during this booting process).
If there is no transducer connected, No Transducer is displayed!
Important
Please wait until the DMP41 indicates it is ready for measurement on the
device start screen.
A03470_07_E00_00 HBM: public
è
Chapter 4.2,
Starting up
Switching on
43