Instantaneous Sensitive Earth Fault Protection (50Sef); Figure 3.5.1-1 Logic Diagram: Sef Directional Element (67Sef) - Siemens Argus 7SR21 Technical Manual

Figure 3.5.1-1
3.5.2

Instantaneous Sensitive Earth Fault Protection (50SEF)

Two instantaneous SEF elements are provided in the 7SR21 relay. Four elements are provided in the 7SR22
relay e.g. giving the option of using two elements set to forward and two to reverse.
Each instantaneous element has independent settings for pick-up current 50SEF-n Setting and a follower time
delay 50SEF-n Delay. The instantaneous elements have transient free operation.
Where directional elements are present the direction of operation can be set using 50SEF-n Dir. Control setting.
Directional logic is provided independently for each 50SEF-n element.
Operation of the instantaneous earth fault elements can be inhibited from: -
Inhibit 50SEF-n
79 SEF Inst Trips: 50SEF-n
50SEF-n VTSAction: Inhibit
Directional elements will not operate unless the zero sequence voltage (V
Voltage setting i.e. the residual voltage is greater than 3 times this setting and the phase is in the
Forward/Reverse operating range. If 67SEF Wattmetric is set to Enabled, the calculated residual real power
must be above the 67SEF Wattmetric Power setting for any SEF element operation. The residual power P
equal to the wattmetric component of 3V
Unrestricted ©2018 Siemens Protection Devices Limited
Logic Diagram: SEF Directional Element (67SEF)
A binary or virtual input, function key or remote data Comms
When 'delayed' trips only are allowed in the auto-reclose sequence
(79 SEF Prot'n Trip n = Delayed).
Operation of the VT Supervision function (7SR22).
I and therefore the wattmetric component of 9V
0 SEF
7SR210 & 7SR220 Description of Operation
) is above the 67SEF Minimum
0
I
0 0
is
res
Page 39 of 94