KaVo ESTETICA E30 Instructions For Use Manual page 35

Water pressure
Max. static pressure water
Water flow
Air pressure
Max. static pressure air
Air flow
Water supply
The ESTETICA E30 treatment centre, as delivered, is not equipped
with an amalgam separator.
Contamination of wastewater.
▶ Disposing wastewater, it is imperative to comply with the national regula-
tions, in particular with regard to amalgam loads.
Note
KaVo recommends to connect an external amalgam separator to the ESTET-
ICA E30 treatment centre in compliance with the specifications of the manu-
facturer of the device.
Note
If the water is very hard (above 12 °dH), a water softening device must be
fitted in the ion-exchange process.
Insufficient water hardness (below 8.4 °dH) can promote the formation of al-
gae.
Note
The "water inlet block" assembly kit does not include a separation between
the treatment water and water supplied by the local mains. The operator
must observe and comply with relevant national directives concerning the
prevention of backflow. Upon failure to comply with these rules, the manu-
facturer accepts no liability for the quality of the treatment water and the mi-
crobial re-contamination of the public drinking water network.
There is a risk of infection if you fail to comply with national regula-
tions.
Contamination of the treatment water and/or drinking water supply with
germs.
▶ Note and comply with national regulations concerning the quality of water
for human use (drinking water) - if applicable.
▶ Note and comply with national regulations concerning the prevention of
backflow (flow from the treatment centre back to the public water supply) -
if applicable.
3 Product description | 3.10 Technical data
1.5 ± 0.3 bar; Flow pressure; 4 x
manometer
2.5 ± 0.3 bar
80 ± 10 ml/min
3.3 ± 0.1 bar; Flow pressure; 4 x
manometer
4 + 0.5 bar
at least 16 Nl/min
CAUTION
WARNING
35 / 134
Instructions for use ESTETICA E30