Setparameter - Siemens SIMATIC RF650R Configuration Manual

XML interface
8.3 XML commands
Parameter
Parameter
value_id
8.3.2.7

setParameter

This command sets a specific parameter for the reader.
Changes using this command are stored in volatile memory in the configuration of the WBM.
As a result, the reader works with the value specified with "setParameter" but does not
display this in the WBM.
Note that the reply frame of the reader can take up to 20 seconds.
Command
<frame>
<cmd>
</cmd>
</frame>
Reply
<frame>
<reply>
</reply>
</frame>
The error codes for negative replies ("resultCode" ≠ 0) are described in the section "Negative
XML replies (Page 211)".
156
Type
Decimal value
0...9
<id> value_id </id>
<setParameter>
<name> value_name </name>
<value> value_value </value>
<objType> value_objType </objType>
<objName> value_objName </objName>
</setParameter>
<id> value_id </id>
<resultCode> 0 </resultCode>
<setParameter/>
Values Description
0...4294967295 Unique command identifier
Configuration Manual, 10/2015, C79000-G8976-C386-03
SIMATIC RF650R/RF680R/RF685R