Set_Param - Siemens SIMATIC RF650R Configuration Manual

7.6.2.5

Set_Param

With the "Set_Param" block, you can change UHF parameters on an RF680R/RF685R
during runtime (e.g. the antenna power).
Note
Settings saved only temporarily
Note that the parameters in the "Set_Param" block are only stored temporarily. If the power
for the reader is interrupted, the stored values are lost and must be set again.
Figure 7-14
Table 7- 12
Parameter
PARMID
VALUE
SIMATIC RF650R/RF680R/RF685R
Configuration Manual, 10/2015, C79000-G8976-C386-03
"Set_Param" block
Explanation of the "Set_Param" block
Data type
DWORD
DWORD
Interface to the SIMATIC controller
Default values Description
0x00 Parameter identifier
0x00 Parameter value
7.6 Programming Ident blocks
115