Restore To Factory Settings - Siemens SIMATIC RF650R Configuration Manual

The updated firmware is active following the restart.
9.5

Restore to factory settings

This section is intended for both S7 and XML users (RF650R/RF680R/RF685R).
You can reset the configuration of the reader to the factory settings at any time. To reset to
the factory settings, you have the following options available:
● using the Primary Setup Tool as of V4.2 (PST)
for RF650R/RF680R/RF685R
● using the WBM
for RF650R/RF680R/RF685R
These alternative methods are described below.
Note
Resetting to factory settings using the Primary Setup Tool
Remember that it is always possible to reset to the factory settings using the Primary Setup
Tool.
Resetting to the factory settings using the PST
Follow the steps below to reset all settings to the factory settings using the PST:
1. Call up the Primary Setup Tool with "Start > All Programs > Siemens Automation >
SIMATIC > Primary Setup Tool".
2. In the menu bar, select the menu command "Module" > "Reset".
Result: The reader is reset to the original factory settings.
Restoring factory settings using the WBM
Follow the steps below to reset all settings to the factory settings using the WBM:
1. Start your Web browser.
2. Enter the IP address of the reader in the address field of your browser.
3. If not logged in, log in to the WBM.
4. Click on the "System" menu item.
5. In the "Restore" area, click the "Restore" button.
Result: The reader is reset to the original factory settings. The restore process is indicated in
the information bar.
Note that if you restore to factory settings the RF650R reader is assigned the factory default
IP address "192.168.0.254". In the factory settings, the RF680R and RF685R readers are
set to DHCP. Because the IP address is discarded, it is possible that the connection
SIMATIC RF650R/RF680R/RF685R
Configuration Manual, 10/2015, C79000-G8976-C386-03
Service and maintenance
9.5 Restore to factory settings
245