XML interface
8.3 XML commands
8.3.3.10
readTagField
This command reads data from the selected transponder. The address of the data area is
specified by the name of a tag field. The tag field and the name of the field are specified
using the WBM. If no EPC-ID is made available or detected, the command is executed with
all the transponders recognized from the read point.
Note
If no EPC-ID is specified, the results are influenced by all the set filter mechanisms (refer to
the section "The "Settings - Filters" menu item (Page 60)"). Then in the reply frame, only the
tags that were not filtered out appear. If an EPC-ID is specified, the data filter has no effect.
The reply frame contains the IDs of all identified transponders. A flag for each transponder
indicates whether or not the command was successful for this transponder.
If no transponder was identified, a negative reply is returned.
Command
<frame>
<cmd>
</cmd>
</frame>
// opt → Optional: Line can be omitted.
194
<id> value_id </id>
<readTagField>
<sourceName> value_sourceName </sourceName>
<tagID> value_tagID </tagID>
<password> value_password </password>
<tagField>
<fieldName> value_fieldName </fieldName>
</tagField>
...
<tagField>
...
</tagField>
</readTagField>
// opt
// opt
Configuration Manual, 10/2015, C79000-G8976-C386-03
// opt
// opt
SIMATIC RF650R/RF680R/RF685R