Programming The Ident Profile; Structure Of The Ident Profile - Siemens SIMATIC RF650R Configuration Manual

Results
Table 7- 18 ATTRIBUTE "0x89" ("IID_READER_STATUS_89_RF68xR" data type)
Name
status_info
hardware_version
firmware_version
config ID
inventory_status
sum of filtered tags
filtered_smoothing
filtered_blacklist
filtered data-filter
filtered RSSI thresold
filtered RSSI delta
7.7

Programming the Ident profile

7.7.1

Structure of the Ident profile

Note
Parallel operation using Ident blocks and Ident profile is not possible
Note that the reader cannot be operated at the same time using the Ident blocks and the
Ident profile.
The blocks described in the section"Programming Ident blocks (Page 103)" represent a
simplified interface of the Ident profile. If the functionality available with the blocks is not
adequate for your application, you can use the Ident profile as an alternative. Using the Ident
profile, you can set complex command structures and work with command repetition. The
following graphic shows the Ident profile including the commands that can be implemented
with it.
Note
Ident profile for trained users
The Ident profile is a complex block containing all the functionality of the Ident blocks. The
Ident profile was developed specially for trained block users who want to configure complex
functions with their own blocks. For untrained users, we recommend using the Ident blocks.
SIMATIC RF650R/RF680R/RF685R
Configuration Manual, 10/2015, C79000-G8976-C386-03
Type Comment
BYTE SLG-Status mode(Subcommand)
BYTE Version of hardware
ARRAY[1..4] of Version of firmware
CHAR
DWORD Unix timestamp
WORD 0=inventory not active;1=inventory active;2=presence
mode active
WORD All filtered Tags
Filtered Tags trough Smoothing
WORD
Filtered Tags trough Blacklist
WORD
WORD Filtered Tags trough Data-Filter
WORD Filtered Tags trough RSSI Threshold
WORD Filtered Tags trough RSSI Delta
Interface to the SIMATIC controller
7.7 Programming the Ident profile
121