Interface to the SIMATIC controller
7.3 Project preparations
7. Drag the data type element "System data types" from the "Global libraries" tab to the
"PLC data types" folder of your project in the project tree.
8. Drag the "Ident_Profile" block from the "Global libraries" tab to the "Program blocks"
folder of your project in the project tree.
Figure 7-1
Inserting blocks and data types in the project
Result: The PLC data types and blocks required to configure the Ident blocks are copied to
your project.
Note
Ident profile is required
Note that the Ident profile also needs to be integrated in your project even if you only work
with the Ident blocks. When executing commands, the Ident blocks access the Ident profile.
96
SIMATIC RF650R/RF680R/RF685R
Configuration Manual, 10/2015, C79000-G8976-C386-03