Siemens SIMATIC RF650R Configuration Manual page 15

Procedure as S7 user
1. Connect the hardware
You will find information on this in the section "Connect the hardware (Page 19)".
2. Assign the IP address / device name
You will find information on this in the section "Assigning the IP address / device name
with the PST (Page 23)" or "Assigning the IP address / device name with STEP 7
(Page 25)".
3. Configure reader and if applicable communications module
You will find information on this in the section "Configuration via STEP 7 (PROFINET
device) (Page 29)" and "Configuring with the WBM (Page 33)".
4. Configure / program reader commands
You will find information on this in the section "Interface to the SIMATIC controller
(Page 93)".
Procedure as XML user
1. Connect the hardware
You will find information on this in the section "Connect the hardware (Page 19)".
2. Assign the IP address / device name
You will find information on this in the section "Assigning the IP address / device name
with the PST (Page 23)".
3. Configure the reader
You will find information on this in the section "Configuring with the WBM (Page 33)".
4. Program reader commands
You will find information on this in the section "XML interface (Page 139)".
Later in the document, these symbols will help your orientation and will show you whether
the section is of interest to you or not. Only the sections with user-specific content, in other
words content that is tool/interface-specific contain these symbols. Sections without these
symbols are general and relevant for both areas of application.
SIMATIC RF650R/RF680R/RF685R
Configuration Manual, 10/2015, C79000-G8976-C386-03
Description
3.2 User-specific procedures
15