ABB ACH550-UH User Manual page 447

ACH550 E-Clipse Bypass User's Manual
Miscellaneous system control
Note: Control of system commands is dependent upon the setting of bypass
parameter 1625.
Using the fieldbus miscellaneous system control requires:
• Bypass parameter values set as defined below.
• Fieldbus controller supplied reference word(s) in the appropriate location. (The
location is defined by the Protocol Reference, which is protocol dependent.)
Bypass
Parameter
1602
1603
1604
1605
1606
1607
1625
Value
2 ( )
RUN COMM
(Not
ENABLE
Recommended)
2 ( )
START COMM
1 (Not
ENABLE
Recommended)
2 ( )
START COMM
2 (Not
ENABLE
Recommended)
2 ( )
START COMM
3 (Not
ENABLE
Recommended)
2 ( )
START COMM
4 (Not
ENABLE
Recommended)
2 ( )
RESET COMM
SRC
1 ( )
COMM SYSTEM
CTRL
Setting Modbus
Run enable by 40001 bit 2
fieldbus.
Source for start 40001 bit 4
enable 1 is the
fieldbus
Command word.
Source for start 40001 bit 5
enable 2 is the
fieldbus
Command word.
40001 bit 6
40001 bit 7
Fault reset by 40001 bit 1
fieldbus
Enable System N/A
Control.
Protocol Reference
N2 FLN BACnet
BO2 35 BV12
BO10 50 BV15
BO11 51 BV16
BO12 52 BV17
BO13 53 BV18
BO3 94 BV14
Embedded fieldbus
2-101