ABB ACH550-UH User Manual page 416

2-70
Code Name
1615 SAVE
PARAM
1616 DISP ALRMS
1617 DRIVE TEST
1618 PASS CODE
1619 PAR LOCK
1620 RUN EN TXT
1621 ST EN1 TXT
1622 ST EN2 TXT
1623 ST EN3 TXT
Parameters
Group 16: System Control
Resolution Range
1 0 = DONE
1 = SAVE
1 0 = DISABLE
1 = ENABLE
1 0 = DISABLE
1 = ENABLE
1 0 - 65535
1 0 = LOCKED
1 = OPEN
1 0 = RUN ENABLE
1 = DAMPER END SWTCH
2 = VALVE OPENING
3 = PRE-LUBE CYCLE
1 0 = START ENABLE 1
1 = VIBRATION SWITCH
2 = FIRESTAT
3 = FREEZESTAT
4 = OVERPRESSURE
5 = VIBRATION TRIP
6 = SMOKE ALARM
7 = SAFETY OPEN
8 = LOW SUCTION
1 0 = START ENABLE 2
...
1 0 = START ENABLE 3
...
ACH550 E-Clipse Bypass User's Manual
Default Description
0 Save User Settings (SaveImm +
SavePwrd).
ENABLE Enables alarms to be displayed:
(1) INP PHASE A LOSS,
INP PHASE B LOSS,
INP PHASE C LOSS,
MTR OVERLOAD,
BYPASS DISABLED,
DRIVE SETUP,
PCB TEMP
DRIVE LINK ERROR
DRIVE FAULTED
DISABLE Enables drive test mode. Drive
(0) contactor is opened.
0 Enter correct password to here in
order to change value of the PAR
LOCK. Default password value is
"123".
OPEN When switched to "LOCKED"
(1) prevents parameter changes
from panel. Does not affect to
Field Bus writes, expect
changing the lock value itself:
correct password must always be
set first, even in case of Field
Bus.
RUN Alternative text choices for alarm
ENABLE 4006.
(0)
START Alternative text choices for alarm
ENABLE 4021.
1
(0)
START Alternative text choices for alarm
ENABLE 4022.
2
See parameter 1621 for range.
(0)
START Alternative text choices for alarm
ENABLE 4023.
3
See parameter 1621 for range.
(0)