ABB ACH550-UH User Manual page 424

2-78
Group 53: Drive EFB
Code Name
5301 DV PROT ID
5302 DV MAC ID
5303 BAUD RATE
5304 EFB PARITY
5305 PROFILE
5306 DV OK MSG
5307 DV CRC ERR
5308 UART
ERROR
5309 DV STATUS
5310 DV PAR 10
... ...
5318 DV PAR 18
5319 DV PAR 19
... ...
5320 DV PAR 20
Parameters
Group 53: Drive EFB
Resolution Range
hex 0x0000 - 0xFFFF
1 0 - 65535
0.1 kbit/s 1.2, 2.4, 4.8, 9.6, 19.2,
38.4, 57.6, 76.8
1 0=8 NONE 1,
1=8 NONE 2,
2=8 EVEN 1,
3=8 ODD 1
1 0=ABB DRV LIM,
1=DCU PROFILE,
2=ABB DRV FULL
1 0 - 65535
1 0 - 65535
1 0 - 65535
1 0=IDLE,
1=EXECUT INIT,
2=TIME OUT,
3=CONFIG ERR,
4=OFF-LINE,
5=ON-LINE,
6=RESET,
7=LISTEN ONLY
1 0 - 65535
hex 0x0000 - 0xFFFF
ACH550 E-Clipse Bypass User's Manual
Default Description
0x0000 All of drive's Group 53 must be
replicated on bypass, since drive
is configured for Modbus. All
Group 53 functionality associated
with selection by 98.02 shall be
hosted on bypass controller for
drive. Similar parameters shall
be allocated for bypass.
1 Drive station ID (NODE
ADDRESS)
9.6 Defines the communication
speed of the RS485 link in kbits
per second (kb/s).
0 Defines the data length, parity
and stop bits to be used with the
RS485 link communication.
— Selects the communications
profile used by the EFB protocol.
0 Contains a count of valid
messages received by the drive.
• During normal operation, this
counter is increasing
constantly.
0 Contains a count of the
messages with a CRC error
received by the drive.
0 Contains a count of the
messages with a character error
received by the drive.
0 Contains the status of the drive
EFB protocol.
0
0x0000