ABB ACH550-UH User Manual page 420

2-74
Code Name
3004 COMM LOSS
3005 COMM TIME
3006 PHASE LOSS
3007 PHASE SEQ
3008 BYPASS MOL
Group 32: Supervisory Control
Code Name
3201 SUPER
CTRL
3202 START LVL
3203 STOP LEVEL
3204 START DLY
3205 STOP DLY
3206 FBK LOSS
Parameters
Group 30: Fault Function
Resolution Range
1 0 = NOT SEL
1 = FAULT
2 = CONST SP7
3 = LAST SPEED
0.1s 0.0 - 600.0s
1 0 = DISABLE
1 = ENABLE
1 0 = DISABLE
1 = ENABLE
1 50 - 150%
Group 32: Supervisory Control
Resolution Range
1 0 = DISABLE
1 = ENABLE
1% 0 - 100%
1% 0 - 100%
1s 20 - 3600s
1s 20 - 3600s
1 0 = BYP STOP
1 = BYP START
ACH550 E-Clipse Bypass User's Manual
Default Description
NOT SEL This parameter serves similar
(0) purpose as parameter 3018 in
drive which specifies behavior if
Modbus link goes down.
Difference is that this parameter
applies in drive and bypass
modes and if drive node or
bypass node detects a problem.
10.0s Sets the communication fault
time used with COMM LOSS
parameter.
1 Disable for input phase loss.
1 Disable for input phase
sequence fault.
110% Motor Overload trip level as % of
ACH550 parameter 9906
MOTOR NOM CURR.
Default Description
DISABLE Enable supervisory control in
( 0) bypass mode.
70% Value of drive's AI2 that causes
bypass contactor closure.
Applies only in supervisory
mode.
30% Value of drive's AI2 that causes
bypass contactor opening.
Applies only in supervisory
mode.
40s Time that close condition must
be present before contactor is
closed.
Applies only in supervisory
mode.
60s Time that open condition must be
present before contactor is
opened.
Applies only in supervisory
mode.
BYP Bypass contactor operation if
START drive link fault, drive AI2 loss or
(1) excessive cycling.