ACH550 E-Clipse Bypass User's Manual
Connection diagrams – Standard E-Clipse Bypass (R8, floor mounted)
ACH550 Standard E-Clipse Bypass units are configured for wiring access from the
top. The following figure shows the Standard E-Clipse Bypass (floor mounted) wiring
connection points. Refer to the ACH550-UH User's Manual on page
control connections to the drive.
Motor Terminals
Input Power
Terminals
E-Clipse Bypass
Control Board
Terminals ( x2)
Disconnect Switch
or Circuit Breaker
Service Switch
(optional)
ACH550
Control Board
Terminals ( x1)
Ground Lug Bar
ACH550 Drive
B4
2-15
for
1-315
Installation