FUEL & ENGINE
FUEL PUMP UNIT
• Quick connect fitting (fuel pump side) 2-2
• Fuel tank 2-6
•
Loosen the nuts in a crisscross pattern in several steps.
• Carefully remove the fuel pump unit from the fuel tank to prevent damaging the fuel level sensor.
•
Install a new outer packing onto the fuel pump unit groove by aligning the tab with the boss.
•
Set the setting plate onto the fuel pump by aligning the hole and boss.
•
Install the fuel pump into the fuel tank by aligning the fuel pump 5P connector with the triangle mark.
•
Tighten the fuel pump setting plate nuts in the specified sequence as shown.
•
Make sure that the outer packing tab can see in the setting plate hole.
• Fuel pump malfunction and inspection
2-4
12 N·m