Canbus Monitor - Furuno FAR-1416 Operator's Manual

5. Press the right button to stop the function test.
7.8

CANbus Monitor

You can check the CANbus data from the CANbus monitor. These data can be saved
in the USB flash memory.
1. Open the [MAIN MENU].
2. Select [INITIAL SETTING], then press the left button.
3. Select [TEST], then press the left button.
4. Select [CANbus MONITOR], then press the left button.
The sentences for NMEA2000 appear.
Go to step 9 when you do not save the log.
SELF TEST (PLOTTER)
Start Time : 2017/--/-- 00:00 Total Count : 10
Main
Application 0359394-xx.xx
First Booter 0359391-xx.xx
Second Booter 0359392-xx.xx
Operating System 0359393-xx.xx
CPU temperature 42.000
LAN (WIRED) OK (NG : 0)
CAN NG (1)
USB1 (RCU) NG (1)
USB2 NG (1)
USB3 NG (1)
INTERNAL MEMORY
TOTAL LCD RUN HOURS 11h--m--s
MIPI OK (NG : 0)
MAC 00:40:9D:8A:FC:30
CAN ID C078C800E7E0000
RUNNING HOURS 0h--m--s
TRIP DISTANCE 600.00000NM
PRESS RIGHT BUTTON : END TEST AND GO BACK
CANbus MONITOR
PLAYING
RX
TX
PRESS LEFT BUTTON : RECORD START/STOP
PRESS RIGHT BUTTON : CLOSE
[GO TO] : SWITCH DISPLAY STATE
[WPT] : CANbus CONNECTION DEVICE DISPLAY
7. MAINTENANCE, TROUBLESHOOTING
Key
Bootloader Ver. 0359260-xx.xx
Apprication Ver. 0359252-xx.xx
SELF TEST RESULT OK (NG : 0)
Power
Bootloader Ver. 1451469-xx.xx
Apprication Ver. 1451470-xx.xx
SELF TEST RESULT OK (NG : 0)
POWER SOURCE VOL 23.9volt
NO USB
7-11