How To Set The Vrm Unit Of Measurement; How To Show Ttg To Vrm - Furuno FAR-1416 Operator's Manual

Using the VRM control box
1. Press the CURSOR ON/OFF key, when the cursor is not shown.
2. Move the cursor onto the VRM box (VRM1 or VRM2), then press the left button.
3. Rotate the scrollwheel to move the cursor onto the inside edge of target, then
press the left button and read the distance from own ship location to the target.
4. Move the cursor onto the VRM box, then press and hold the left button to erase
the selected VRM.
VRM range marker hides as marker indicated condition.
• Both of VRM1 and VRM2 indicated and VRM1 (or 2) is activated: VRM2 (or 1)
• VRM1 (or VRM2) only indicated: VRM1 (or 2)
1.31.3

How to set the VRM unit of measurement

VRMs can be displayed in the following units of measure-
ment:
• NM (Nautical Miles)
• SM (Statute Miles)
To change the unit of measurement, do the following:
1. Open the [MAIN MENU].
2. Select [CURSOR OWN SHIP MARK], then press the
left button.
3. Select [EBL/VRM], then press the left button.
4. Select [VRM1] or [VRM2] as appropriate, then press
the left button.
5. Select the unit of measurement, then press the left but-
ton.
6. Close the menu.
1.31.4

How to show TTG to VRM

TTG (Time To Go) to a selected VRM can be displayed as follows:
1. Open the [MAIN MENU].
2. Select [CURSOR OWN SHIP MARK], then press the left button.
3. Select [EBL/VRM], then press the left button.
4. Select [VRM TTG], then press the left button.
5. Select [OFF], [1], [2] or [1&2] as appropriate, then press the left button.
• [OFF]:
• [1]:
• [2]:
• [1and2]:
6. Close the menu.
• KM (Kilometers)
No TTG to VRM displayed.
TTG to VRM1 displayed.
TTG to VRM2 displayed.
TTG to VRM1 and VRM2 displayed.
TTG indication
01:15
VRM1
1. OPERATIONAL OVERVIEW
[EBL/VRM]
1. BACK
2. EBL 1
3. EBL 2
4. VRM 1
5. VRM 2
6. EBL OFFSET BASE
7. VRM TTG
8. VRM OFFSET
>3.682NM<
REL/TRUE
REL/TRUE
NM/km/SM
NM/km/SM
STAB GND/STAB HDG/
STAB NORTH
OFF/1/2/1+2
OFF/LINE EBL
1-39