How To Use The Circle Line - Furuno FAR-1416 Operator's Manual

1. OPERATIONAL OVERVIEW
4. Select [FRONT HALF LENGTH], then press
the left button.
Rotate the scrollwheel and press the left but-
ton to set the front half length of net (max.
3000 m).
5. Select [REAR HALF LENGTH], then press the
left button.
Rotate the scrollwheel and press the left but-
ton to set the rear half length of net (max.
3000 m).
6. Select [NET WIDTH], then press the left but-
ton.
Select [360°] or [32 POINTS], then press the left button.
The net cursor moves as EBL2 moving. Select [360°] to move with 0.1° step, or
select [32 POINTS] to move with 11.25° step.
7. Close the menu.
8. Stab the net cursor on the location of net casting with EBL offset function.
1) Press the EBL OFFSET key.
2) Move the cursor onto the casting point, then press the left button.
9. Rotate the EBL knob to adjust the orientation the net cursor until the cursor is in
line with the tide flow direction (or against direction).
1.40

How to Use the Circle Line

You can use a circle line to measure the distance between two points.
1. Press the CURSOR ON/OFF key to appear the cursor when cursor is not shown.
2. Rotate the scrollwheel to select [SET CIRCLE LINE], then press the left button.
A circle appears on the screen, and the circle radius range box appears at the left
side of screen.
3. Move the cursor onto the start point to set the circle line.
4. Rotate the scrollwheel to adjust the radius range, then move the cursor onto the
end point and press the left button.
5. Press the right button to close the menu.
To erase the circle line, rotate the scrollwheel to select [SET CURSOR LINE],
then press the left button and press the right button further.
1-56
Cursor
Circle radius
range box
a
Forward length of net Forward length of net Forward length of net
Net width
Rear length of net Rear length of net Rear length of net
b
Circle line