Furuno FAR-1416 Operator's Manual page 132

5. VIDEO PLOTTER OPERATION
4. Press the left button or MARK key to enter the second mark.
The relative distance and heading data appears near by cursor.
5. Repeat step 7 and 8 to enter the marks.
6. Press the right button to exit the mark function.
Note 1: This function is invalid after ten seconds of no operation.
Note 2: The cursor information display function is invalid while this relative loca-
tion information is used. When the mark entering is finished, the cursor informa-
tion display can be used.
Enter a mark onto the location at specified L/L
1. Open the [MAIN MENU].
2. Select [MARK], then press the left button.
3. Select [INPUT MARK], then press the left button.
The mark input window appears.
4. Select [LATITUDE], then press the left button.
5. Rotate the scrollwheel to set the location by latitude, then press the left button.
Rotate the scrollwheel to toggle between N (North) and S (South).
6. Select [LONGITUDE], then press the left button.
7. Rotate the scrollwheel to set the location by longitude, then press the left button.
Rotate the scrollwheel to toggle between E (East) and W (West).
8. Select the mark color, shape, line type and fish type as outlined in
paragraph 5.2.1.
9. Select [RUN], then press the left button.
10. Press the right button to close the window.
5-16
1.156NM
77.6°R
Setting line type
Cursor
Start point (Mark)
Start point (Mark)
INPUT MARK
LATITUDE : 34° 44.0000' N
LONGITUDE : 135° 21.0000' E
RUN
Range and
bearing from
the start point