Alert Settings; How To Set The Ais Target Alert; How To Set The Lost Target Filter - Furuno FAR-1416 Operator's Manual

ed vector time has ended. You can foresee a risk of collision with other AIS targets by
extending the vector length (time).
How to select the vector mode and time
Vectors may be displayed in true (over ground/ over water) or relative reference. Vec-
tor time can be selected from 15/30/45 sec., 1 to 60 minutes. The settings are common
with TT target.
1. Press the CURSOR ON/OFF key when the cursor is not shown on the screen.
2. Move the cursor onto the character R or T (rela-
tive or true) on vector box at left-bottom on the
screen, then press the left button.
Every press alternately changes [R] or [T].
3. Move the cursor onto the vector time box, then
press the left button to select a vector time in
ascending order (30 sec. and 1 min. to 60 min.) with interval. Use the scrollwheel
to select 1 min. step.
4.8

Alert Settings

4.8.1

How to set the AIS target alert

1. Open the [MAIN MENU].
2. Select [ALERT SETTINGS], then press the left button.
3. Select [TT/AIS ALERT], then press the left button.
4. Select [AIS PROXIMITY ALERT], then press the left button.
5. Select [ON], then press the left button. The settings can now be adjusted.
6. Rotate the scrollwheel to adjust the setting as required, then press the left but-
ton to apply the setting.
7. Close the menu.
When an alert occurred, audible alarm generated and alert message appears on the
massage area. To cancel the AIS proximity alert, select [OFF] at the step 5.
4.8.2

How to set the lost target filter

If there are a lot of AIS targets in your area, the lost target alert can sound frequently.
In this case you may wish to have the alert ignore lost targets whose range, speed,
class or length are below the threshold value you specify.
1. Open the [MAIN MENU].
2. Select [ALERT SETTINGS], then press the left button.
3. Select [TT/AIS ALERT], then press the left button.
4. Select [NEXT], then press the left button.
5. Select [AIS LOST FILTER], then press the left button.
6. Select [ON], then press the left button. The settings can now be adjusted.
7. Rotate the scrollwheel to adjust the setting as required, then press the left but-
ton to apply the setting.
4. AIS OPERATION
Relative/ True mode
VECTOR R
Vector box
6 MIN
Vector time
4-7