How To Show The Mark Information - Furuno FAR-1416 Operator's Manual

5. VIDEO PLOTTER OPERATION
1. Open the [MAIN MENU].
2. Select [MARK], then press the left button.
3. Select [EDIT MARK], then press the left button.
4. Press the right button to select [SEL. METHOD].
5. Select the method to edit and press the left button.
1) Cursor: edits the mark/line selected by the cursor.
2) Set range: edits the specified marks/lines in the selected area.
3) Within range: edits all specified marks/lines displayed on the screen.
4) Out of range: edits all specified marks/lines not displayed on the screen.
Select the color, shape, line type, fish type and comment with the scrollwheel.
6. Do the following operation if you select a method of [CURSOR] or [SET RNG].
• [CURSOR]: Select a mark to edit.
• [SET RNG]: Select an area to edit with start/end points.
7. Select [COLOR], then press the left button.
8. Rotate the scrollwheel to select a color, then press the left button.
Select [NO CHG.] if you do not change the color.
9. Select mark shape, line type and fish type as same manner on step 7 and 8.
10. Select [COMMENT], then press the left button.
11. Change the comment refer to paragraph 1.8.3.
Select [NO CHG.] if you do not change the comment.
12. Select [RUN], then press the left button.
5.2.5

How to show the mark information

Basic information
1. Press the CURSOR ON/OFF key when the cursor is not shown.
2. Place the cursor on the mark whose information you want to view.
The information shown is: location (Lat/Lon), water temperature and water depth.
5-18
EDIT MARK
SEL METH. : 1. CURSOR 2. SET RNG
4. OUT OF RNG
NO. OF MRK SELECTED 0
1 2 3 4 5 6 7 8 9 0
ALBACORE BNT1
SW CRB POLLOCK JP ANCH
ANC WITHOUT NO CHG.
COMMENT : NO CHG.
RUN
TURN WHEEL : SELECT PRESS LEFT BUTTON : ENTER
PRESS RIGHT BUTTON : CLOSE
3. WITHIN RNG
8. NO CHG.
NO CHG.
5. NO CHG.
BNT2 MAC
SAU