1. OPERATIONAL OVERVIEW
Function
category
PICTURE
CUSTOM1, CUSTOM2, CALM, RAIN, HEAVY RAIN, ABA, PICK, COAST,
OCEAN, BOUY
6. Select the appropriate function to assign, then press the left button.
7. Close the menu.
Repeat the procedure as necessary to set up other function keys.
1.14
How to Select the Interface for Heading Input
When a gyrocompass is connected, the ship's heading appears on the right side of the
screen, in the data display area.
Heading input format can be selected as follows:
1. Place the cursor on the [HDG] box at the top-left of the screen, then press the
right button. The [HDG] context menu appears.
2. Select [HDG SOURCE], then press the left button.
3. Select [AD-10] or [SERIAL] as appropriate, then press the left button.
This refers to the type of connection, [AD-10] is for AD-10 format (FURUNO orig-
inal) connection, [SERIAL] is for serial connections.
4. Close the menu.
Note: The heading sensor must be able follow a minimum ROT of 20° per second.
Heading sensors with a lesser capability may degrade the performance of echo aver-
aging, trails and TT. The data refresh rate should also be as short as possible. If the
refresh rate is too long, the ability to follow courses lessens, thereby affecting the per-
formance of echo averaging, trails and TT.
1.15
How to Set Own Ship's Speed
The TT and azimuth stabilized presentation modes require own ship speed input and
compass signal. The speed can be entered from a log (STW, SOG) or GPS (SOG) or
manually on the menu.
Note: Where the own ship speed exceeds 99.9kn, the displayed speed is "99.9kn".
1.15.1
Automatic speed input (log or GPS navigator)
1. Select the [NAV DATA] menu from the [MAIN
MENU], then press the left button.
The [NAV DATA 1/2] menu appears.
2. Select [SHIP SPEED SETTING], then press the left
button to show the [SPEED SETTING] menu.
3. Select [SHIP SPEED], then press the left button.
1-20
Available function
[SHIP SPEED SETTING]
1. BACK
2. SHIP SPEED
LOG(BT) / LOG(WT) /
GPS
3. SET DRIFT
OFF/ON
000.0°
0.0kn