Furuno FAR-1416 Operator's Manual page 158

5. VIDEO PLOTTER OPERATION
2. Press GO TO key to open the [SELECT WPT] window.
000007
3. Use the scrollwheel, MARK COLOR key or MARK key to enter the waypoint
number to be set as a destination to the [ENTER WPT NO], then press the left
button.
A light blue line will be drawn between own ship and a waypoint. The distance,
bearing and TTG (factory default) will be displayed.
How to select the waypoint from the log list
The waypoints (up to the latest 10 points) are registered to the log list. Follow the pro-
cedures below to select the waypoints from the listed points. When the number of reg-
istered waypoints exceed 10, the oldest waypoint will be deleted.
1. Press the CURSOR ON/OFF key if a cursor is not shown.
2. Press GO TO key to display the [WAYPOINTS LIST] window.
3. Press the WPT key.
Data input cursor moves to the waypoint log.
000007
000006
4. Select the waypoint to set as a destination, then press the left button.
A light blue line will be drawn between own ship and a waypoint. The distance,
bearing and TTG (factory default) will be displayed on the upper side of display
unit.
5-42
34' 21.3992' N 135'06.5654' E
34' 21.3992' N 135'06.5654' E
34' 21.3790' N 135'08.6011' E
0.00NM 20:42 1610.03
0.00NM 20:42 1610.03
0.00NM 20:42 1610.03