How To Select A Display Mode; How To Display And Set Up Navigational Data; How To Set Up The Navigational Data - Furuno FAR-1416 Operator's Manual

1.43

How to Select a Display Mode

• Standard display mode: The operational display area, box functions, data display,
etc. are shown in a standard manner.
• Simple display: The display is echo-focused.
Note: The sea-through picture uses the alpha-blend method.
Follow the procedure below to change display modes.
1. Open the [MAIN MENU].
2. Select [ECHO], then press the left button. The [ECHO] menu appears.
3. Select [NEXT], then press the left button. The [Echo 2/2] menu appears.
4. Select [ECHO AREA], then press the left button.
5. Select the appropriate setting, then press the left button.
• [CIRCLE] mode: The echoes are displayed inside a circle on the screen.
• [WIDE] mode: The echoes are displayed in a square area, but are not displayed
in the data display area.
• [ALL] mode: The echoes are displayed across the entire screen.
6. Close the menu.
1.44

How to Display and Set Up Navigational Data

Wind, depth, ocean current, water temperature, date and time and waypoint data can
be displayed on this radar, however appropriate sensors are required.
1.44.1

How to set up the navigational data

1. Open the [MAIN MENU].
2. Select [NAV DATA], then press the left button.
CIRCLE WIDE ALL
1. OPERATIONAL OVERVIEW
1-61