Select Zoom Expansion; How To Off-Center The Display - Furuno FAR-1416 Operator's Manual

1. OPERATIONAL OVERVIEW
1.27.2

Select zoom expansion

1. Open the [MAIN MENU].
2. Select [ECHO], then press the left button.
3. Select [ZOOM], then press the left button.
4. Select [2TIMES] or [3TIMES], then press the left button.
5. Select [ZOOM DISPLAY], then press the left button.
6. Select the method to expand, then press the left button.
[STAB GND]: stab ground expansion [STAB HDG]: stab relative heading expan-
sion [STAB NORTH]: stab true bearing expansion
7. Close the menu.
1.28

How to Off-Center the Display

Own ship position, or sweep origin, can be displaced to expand the view field without
switching to a larger range scale. The sweep origin can be off-centered to the cursor
position, but not more than 75% of the range in use; if the cursor is set beyond 75%
of the range scale, the sweep origin will be off-centered to the point of 75% of the limit.
This feature is not available on the 96 nm range or in the true motion mode.
If the conning position is outside the effective radar display, some parts of the bearing
scale are not shown. For details, see.
How to off-center the display from the control unit
1. Press the CURSOR ON/OFF key when the cursor is not shown.
2. Move the cursor at the position where you wish to move the sweep origin.
3. Press the OFF CENTER key. The sweep origin is now off-centered at the cursor
position.
4. To cancel off-centering, press the OFF CENTER key again.
How to off-center using cursor function box
1. Press the CURSOR ON/OFF key when the cursor is not shown.
2. Rotate the scrollwheel to select [OFFCENTER] from the cursor function box.
3. Move the cursor onto the location desired.
4. Press the left button.
The sweep origin is off-centered.
1-32
Cursor
Put cursor where desired
and do appropriate
off-center procedure.
Cursor
Off-centered display