F Scan And Fine ∂F Scan (Vfo Mode/Memory Mode); D About The ∂F Scan - Icom IC-7100 Instruction Manual

Previous view
12
SCAN OPERATION
∂F scan and Fine ∂F scan (VFO mode/Memory mode)
D ∂F scan
About the
∂F (Delta Frequency) scan searches for signals within
the specifi ed range with the displayed VFO frequency
or Memory channel frequency as the center frequency.
The frequency range is specifi ed by the width of the
selected span.
q
Touch the Memory channel number indication once
or twice to select the VFO mode or Memory mode.
(p. ??-??)
w
Push (C) one or more times to select the "M-
MENU
1" (Menu 1) screen.
e Touch [SCAN](D) to display the "SCAN" screen.
r
Set [RF/SQL] open or closed.
• The scan performance differs, depending on the squelch
setting when the scan was started. See page 146 for de-
tails.
• If the [RF/SQL] control function is set to "AUTO," the
squelch is always open in the SSB, CW and RTTY
modes. (pp. ??-??, ??-??)
t D) one or more times to select the
Touch [SPAN](
desired ∂F span width.
• ±5 kHz, ±10 kHz, ±20 kHz, ±50 kHz, ±100 kHz, ±500 kHz
and ±1 MHz are selectable.
y
Set the center frequency of the
• In the VFO mode, rotate the Dial to set the center fre-
quency.
• In the memory mode, rotate [M-CH]
desired Memory channel whose frequency will be the
center frequency.
u ∂F](D) to start the ∂F scan.
Touch [
• "∂F SCAN," the MHz and kHz decimal points blink while
scanning.
• If "Up/Down" is selected as the "MAIN DIAL (SCAN)" op-
tion in the Scan Set mode, rotating the Dial changes the
scanning direction. (p. ??-??)
i
When the scan detects a signal, the scan stops,
pauses or ignores it, depending on the Scan Re-
sume function, VSC function or the squelch status.
o ∂F](D) again to cancel the ∂F scan.
Touch [
∂F scan.
(L) to select the
12-14
L eft D isplay R ight
C enter
Set the center frequency
While ∂F scanning (VFO mode)
The L, R, C or D in the
instructions indicate the
part of the controller.
L: Left side
R: Right side
C: Center bottom
D: Display (Touch panel)
Touch
[SCAN]
Touch [SPAN] one or
more times to select
the ∂F span width.
Rotate the Dial
(VFO mode)
Rotate the [M-CH]
(Memory mode)