Mode Select Scan - Icom IC-7100 Instruction Manual

Previous view
12
SCAN OPERATION
Memory scan (Memory mode) (Continued)
D

Mode Select scan

Repeatedly scans all Memory channels with the same
operating mode as the displayed mode.
NOTE: For a Mode Select scan to start, two or more
Memory channels must be programmed, and their
operating mode must be the same as the displayed
mode.
q q through e as described above to
Follow steps
display the "SCAN" screen.
w D) for 1 second, and then touch
Touch [MEMO](
"MODE-SEL" to start the Mode Select scan.
• The MHz and kHz decimal points, and "MODE-SEL
SCAN" blink while scanning.
• If "Up/Down" is selected as the "MAIN DIAL (SCAN)" op-
tion in the Scan Set mode, rotating the Dial changes the
scanning direction. (p. ??-??)
e
To change the operating mode while scanning, touch
the mode icon to display the Mode selection screen,
and then touch the desired operating mode.
r D) to cancel the scan.
Push [MEMO](
L eft D isplay
C enter
While Mode Select scanning
12-11
The L, R, C or D in the
R ight
instructions indicate the
part of the controller.
L: Left side
R: Right side
C: Center bottom
D: Display (Touch panel)
Touch [MEMO]
for 1 second
Touch
"MODE-SEL."
Touch the mode
icon, and then
touch the de-
sired operating
mode