Section 11 Memory Operation; General Description; D Memory Channel Contents - Icom IC-7100 Instruction Manual

Previous view
11
MEMORY OPERATION

General description

The transceiver has a total of 495 Memory channels (99
channels in each of 5 memory banks, A to E), 6 Scan
Edge channels (3 pairs) and two Call channels (C1/C2)
each for the 144 and 430 MHz frequency bands.
The Memory mode is useful to quickly select often-
used frequencies.
While in the memory mode, all 503 Memory channels
are tunable, which means the programmed frequency
can be temporarily tuned with the Dial.
Memory Channels
1–99 (Total of 495)
1A/1B–3A/3B
C1/C2
D
Memory channel contents
The following information can be programmed into
Memory channels:
• Operating frequency (p. ??-??)
• Operating mode (p. ??-??)
• IF fi lter number (p. ??-??)
• Split data (p. ??-??)
( Usable only on the regular Memory channels and
Call channels.)
• Memory name (p. ??-??)
• Duplex direction (DUP+ or DUP–) and frequency off-
set (pp. ??-??)
• Subaudible tone encoder (p. ??-??), tone squelch or
DTCS squelch ON/OFF (pp. ??-??, ??-??)
• Subaudible tone frequency (p. ??-??), tone squelch
frequency or DTCS code with polarity (p. ??-??)
• Destination call sign (p. ??-??)
• R1/R2 call signs (p. ??-??)
• Call sign squelch or Digital code squelch ON/OFF (p.
??-??)
• Digital code (p. ??-??)
NOTE:
Memory content can be erased by static electricity,
electric transients, and other causes. In addition, they
can be erased by a malfunction or during repairs.
Therefore, we recommend that you backup the mem-
ory content or save it to a SD card or to a PC.
• The SD card is not available from Icom. Purchase a
SD card to meet your needs.
• The optional CS-7100
CLONING SOFTWARE
be used to backup your memory data.
Regular Memory channels with split frequency capability.
Program Scan Edge Memory channels with only simplex capability.
Stores the Scan Edge frequencies for programmed scans.
Two Call channels (C1/C2) each for the 144 and 430 MHz frequency bands.
Call channel with split frequency capability. Instantly recalls a specifi ed frequency.
can also
When you tune a Memory channel without storing, and
then go back to the channel again, the original stored
frequency is displayed.
In the Memory mode, touch just above MHz area on
the display, and then select the desired band. Then ro-
tate the Dial to select the frequency to be stored.
Descriptions
L eft D isplay
C enter
11-2
The L, R, C or D in the
R ight
instructions indicate the
part of the controller.
L: Left side
R: Right side
C: Center bottom
D: Display (Touch panel)