Mode Select Scan; D Mode Select Scan Operation; F Scan And Fine ∂F Scan; D ∂F Scan Operation - Icom IC-905 Advanced Manual

7
SCANS

Mode Select scan

Repeatedly scans Memory channels (except C1 and
C2) that are set to the mode selected before starting
the scan�
Ch 00 Ch 01
FM
AM
Only Memory channels set to
Ch 99
FM the FM mode are scanned�
Ch 98 Ch 50
FM DV

D Mode Select scan operation

1� Select the Memory mode�
2� Set the operating mode�
3� Display the SCAN screen�
» SCAN
4� Touch [MEMO] for 1 second�
5� Touch "MODE SELECT SCAN�"
• The Mode Select scan starts�
L When a signal is detected, the scan pauses
according to the "SCAN Resume" setting, and then
resumes�
L To cancel the scan, touch [MEMO]�
6� To close the SCAN screen, push
Ch 02 Ch 03
FM FM
Ch 04
FM
Ch 06 Ch 05
AM FM
Blinks
�
∂F scan and Fine ∂F scan
Repeatedly scans within the ∂F span area� The scan
starts from the center frequency�
146�17 MHz
Scan
Scan edge
L In a Fine scan (Programmed or ∂F), the scan speed
decreases when the squelch opens, but the transceiver
keeps scanning� The scan tuning step changes to 10 Hz
when the squelch opens�
D ∂F scan operation
1� Set the center frequency�
2� Set the operating mode and tuning step�
(Example: FM, 1 kHz)
L You can also change these settings while scanning�
3� Display the SCAN screen�
» SCAN
4� Touch [∂F SPAN] several times to select the span�
• Each touch changes the span�
5� Touch [∂F]�
• The ∂F scan starts�
L When a signal is detected, the scan pauses according
to the "SCAN Resume" setting, and then resumes�
L To turn the TS function to scan by the frequency step
setting, touch the 100 kHz digit on the frequency readout�
L To cancel the scan, touch [∂F] again�
6� To switch to the Fine ∂F scan, touch [FINE]�
• The scan frequency step changes to 50 Hz�
L To return to the ∂F scan, touch [FINE] again�
7� To close the SCAN screen, push
7-9
146�18 MHz 146�19 MHz
Scan
Start
Jump
Center Scan edge
(Example: Span: ±10 kHz)
Blinks
Blinks
�