Table of Contents
Advertisement
4.8.5 How to Reset an FCIP Network Module
Step 1
Before you perform a reset, ensure that you have made all of the desired changes to the FCIP
Network Module. Also, you may configure multiple FCIP Network Modules on an OptiStar
EdgeSwitch before performing a reset using method (b.) below.
Step 2
There are three methods for resetting an individual FCIP Network Module.
a.
To reset from the FCIP Network Module CLI without affecting the OptiStar EdgeSwitch:
At the FCIP Network Module CLI root menu, type reset
b.
To reset the FCIP Network Module by rebooting the entire switch:
- Exit out of the FCIP Network Module CLI by typing logout (versus exit) at the root menu.
- To reboot, from the OptiStar EdgeSwitch main menu, follow the menu path:
[3] Configuration → → → → [2] System Information → → → → [7] Reset OptiStar EdgeSwitch
c.
To reset the FCIP Network Module by disabling and then reenabling the FCIP Network
Module:
- Exit out of the FCIP Network Module CLI by typing logout (versus exit) at the root menu.
- From the OptiStar EdgeSwitch main menu, follow the menu path:
[4] Administration → → → → [2] Set Module Admin Status → → → → Enter Module Number (1-4):
- At the prompt Enter choice: (1-2) prompt, enter a 2 to disable the module.
- To re-enable the module, return to the same option and enter a 1 to enable the module.
4.9 Setting up a Fibre Channel Tunnel Between OptiStar EdgeSwitches
Step 1
First you will need to configure the connecting IP address and subnet mask for each interface
(switching port) on both OptiStar EdgeSwitches, as well as the FCIP Network Module IP addresses
and subnet masks for all FCIP Network Modules. Please follow the steps given in Section 4.8.1 then
continue on to the next step.
Step 2
Next you will need to add the FCIP Network Module IP address of the remote FCIP Network
Module to the Remote FCIP Network Module IP Parameters Table on each OptiStar EdgeSwitch.
Step 3
Go to the CLI main menu for the first OptiStar EdgeSwitch and follow the path:
[3] Configuration → → → → [9] FCIP Network Module Configuration → → → → [3] Add Remote FCIP
Network Module
Step 4
You should now see the following prompts in succession:
Enter the IP Address of Remote FCIP Network Module
Enter an FCIP Network Module IP address that was assigned to the remote FCIP Network Module.
Enter the Subnet Mask of Remote FCIP Network Module
Enter the subnet mask that was assigned to the remote FCIP Network Module.
To check to see if the new information has been added correctly, you may view the Remote FCIP
Network Module IP Parameters
Parameters"
for help).
4 - 4 0
(see Section 5.1.10.2, entitled "Remote FCIP Network Module IP
Lucent Technologies
:
:
365-575-925R1.5
Issue 1, April 2002
Advertisement
Table of Contents
