Routing Configuration; Connecting To An End-Station Or Edge Device Not Supporting Ilmi; Connecting To Another Atm Switch Which Doesn't Support Pnni - Lucent Technologies CAJUN M770 User Manual

For example, if you are connecting a Cajun M400 Gate Switch LSA+ module which
does not support ILMI, to port 8.4.0 on the M770 ATM Switch, you should
configure port 8.4.0 on the M770 ATM Switch by performing the following steps:
M15-155s8:/>vport disable 8.4.0
M15-155s8:/>vport disable 8.4.0 ILMI
M15-155s8:/>vport set stacktype 8.4.0 UNI 3.0
M15-155s8:/>vport set vpirange 8.4.0 [0..0]
M15-155s8:/>vport set vcirange 8.4.0 [32..1023]
M15-155s8:/>vport enable 8.4.0

Routing Configuration

Connecting to an end-station or edge device not supporting ILMI

If you are attaching an end-station or edge device that does not support ILMI then
you must configure a route to that device. For example, if you are connecting a
Cajun M400 Gate Switch LSA+ module to port 8.4.0 on the M770 ATM Switch,
you should configure the static routing by performing the following steps:
[assume that the ATM address of the LSA+ is
39.01.00.00.00.00.00.00.00.00.00.00.00.00.40.od.64.02.de.00]
M15-155s8:/>route add
39.01.00.00.00.00.00.00.00.00.00.00.00.00.40.od.64.02.de 8.4.0
Note: The ATM address should not include the selector.

Connecting to another ATM switch which doesn't support PNNI

If you are attaching another ATM switch that doesn't support PNNI, you must
configure a route to that switch.
For example, if you are connecting a Collage 740 to port 8.5.0 on the M770 ATM
Switch, you should configure the static routing table by performing the following
steps:
[assume that the partial ATM prefix of the Collage 740 is 39.04]
M15-155s8:/>route add 39.04. 8.5.0
Cajun M770 ATM Switch User's Guide
Chapter 2 Getting Started
11