Table of Contents
Advertisement
Conventions Used in This Manual
Unit and Note
Subheadings
Symbols Used in the Syntax
iv
Type
Symbol
Meaning
Unit
k
1000
K
1024
Note
Note
Calls attention to information that is important for proper operation of the
instrument.
On pages that describe operating procedures, the following symbols, displayed
characters, and terminology are used to distinguish the procedures from their
explanations:
Follow the numbered steps. All procedures are written with
Procedure
inexperienced users in mind; experienced users may not need to
carry out all the steps.
This subsection describes the setup parameters and the limitations
Explanation
on the procedures.
Displayed Characters and Terminology Used in the Procedural Explanations
Panel Keys and Soft keys
Bold characters used in the procedural explanations indicate characters that are marked on the
panel keys or the characters of the soft keys or menus displayed on the screen.
SHIFT + Panel Key
SHIFT + key means you will press the SHIFT key to turn ON the SHIFT key followed by the
operation key. The setup menu marked in purple below the panel key that you pressed appears
on the screen.
Symbols which are used in the syntax descriptions in Chapter 6 are shown below.
These symbols are referred to as BNF (Backus-Naur Form) symbols. For details on
the data, see pages 5-5 and 5-6.
Symbol
Meaning
< >
Defined value.
{ }
Select from values
given in { }.
|
Exclusive OR
[ ]
Can be omitted.
Example: 100 kHz
Example: 640 KB (file data size)
Example
ELEMent<x>
<x> = 1 to 4
MODE:{RMS|MEAN|DC|RMEAN}? ->MODE:RMS?
NUMeric[:NORMal]:VALue?
Example of Input
->ELEMENT2
->NUMERIC:VALUE?
IM 760301-17E
Advertisement
Table of Contents
