Controlled By Empower Software; Controlled By Masslynx Software; Perform Automatic Runs In A Standalone Mode - Waters Alliance e2695 Operator's Manual

5 Automatic Runs
Main screen:

Controlled by Empower software

If your HPLC system is controlled by Empower software, you perform an
automatic run using a project, instrument method, configured system, method
set, and sample set stored in software. For details on performing runs using
Empower software, see the procedures in
Empower software control" on page

Controlled by MassLynx software

If your HPLC system is controlled by MassLynx software, you must select an
LC method that defines the separations module's operating parameters and
those of the system's detector (but not the mass spectrometer, if included). For
details on performing a run using MassLynx software, see
runs under MassLynx control" on page

Perform automatic runs in a standalone mode

The following figure shows the steps for setting up and performing an
automatic run in a standalone configuration (System Controller or No
Interaction mode).
136 July 29, 2013, 715003794 Rev. B
"Perform automatic runs under
142.
144.
"Perform automatic