Create Methods, Sample Sets, And Sample Templates; Separation Methods - Waters Alliance e2695 Operator's Manual

6
Create Methods, Sample Sets,
and Sample Templates
Contents:
Topic
Create and edit separation methods ............................................... 146
Set separation method parameters ................................................. 150
Create and edit a sample set ........................................................... 174
Create a sample template................................................................ 180
Chapter 5 explains how to perform an automatic run in a standalone or
remote control mode.
You can create and store the separation methods, sample sets, and sample
templates with which you make automatic runs when the separations module
is in the standalone System Controller mode. You can store up to 60 methods
in the internal memory of the separations module. When the number of stored
methods approaches 60, the maximum, the time required to create and save
methods increases from a few seconds to over 30 seconds. When 60 methods
are stored, a warning message appears indicating that memory capacity is
reached.
The separations module supports three types of tools for controlling automatic
runs in a standalone mode:
•

Separation methods

• Sample sets
• Sample templates
Separation methods
The separations module uses and stores programs that can automatically run
a separation method, which consists of these time-based and nontime-based
conditions that influence the separation:
July 29, 2013, 715003794 Rev. B
Page
145