Table of Contents
Advertisement
Status screen parameters: (Continued)
Parameter
Injector
486 (1) and (2)
• λ
• Lamp
• AUFS
2487 (1) and (2)
• λ
• Lamp
• AUFS
2410 and 410
• Cell
• Col 1
• Col 2
1. Enabled if the optional column heater or column heater/cooler module is configured with the
Waters 2414, 2410, or 410 Differential Refractometer.
Perform direct functions
The following figure outlines the procedure for using the front panel to set up
the separations module to perform a direct function.
Description
Indicates the current position of the needle port. Valid
positions are:
• Stream – In the high-pressure stream
• Seal – In the lower seal position
• Wet – In the needle wash position
• Vial – In the sample vial
Indicates the current status of the following parameters
for the 486 Detector(s) (if installed):
• Wavelength
• Lamp On or Off
• Absorbance Units Full-Scale
Indicates the current status of the following parameters
for the 2487 Detector(s) (if installed):
• Wavelength
• Lamp On or Off
• Absorbance Units Full-Scale
Indicates the current status of the following parameters
for the 2414, 2410, or 410 Detector (if installed):
• Cell Temperature (detector oven temperature)
• External Temp 1
• External Temp 2
1
1
July 29, 2013, 715003794 Rev. B
Perform direct functions
123
Advertisement
Table of Contents
Troubleshooting
