Table of Contents
Advertisement
2 Install the e2695 Separations Module
software installed in the separations module. Similarly, the external remote
management system that controls the separations module must also meet
minimum software requirements. See the Alliance e2695 Separations Module
Release Notes for details on minimum firmware and software requirements.
Unpack
The separations module is shipped on a wooden pallet in a single carton. Save
the carton and pallet in case you decide to transport the unit in the future.
External accessories and options such as columns, column heater, and
detectors are shipped in separate cartons.
To unpack the separations module:
1.
Remove the bands securing the carton to the pallet.
2.
Remove the carton, the carousel box, the solvent bottle tray, the startup
kit, and packing material.
3.
Check the contents of the carton against the packing slip to confirm that
all items are included.
Warning:
must lift the separations module from the pallet to the bench.
4.
Lift the separations module from the pallet, and place it at the
installation site.
5.
Inspect all items for damage, and immediately report any shipping
damage to both the shipping company and your Waters representative.
Requirement:
Service. Refer to Waters Licenses, Warranties, and Support Services for
complete information on shipping damages and claims.
Connect to the electrical power supply
Proper operation of the separations module requires that the AC power supply
be grounded and that has no abrupt voltage fluctuations.
The separations module automatically adjusts for input voltages in the range
of 100 - 240 Vac, 50 - 60 Hz.
48
July 29, 2013, 715003794 Rev. B
To minimize the risk of back injury, at least two people
If shipping damage occurred, contact Waters Customer
Advertisement
Table of Contents
Troubleshooting
