Waters Alliance e2695 Operator's Manual page 163

• Select the system parameter signal sent through the Chart Out
terminals.
To enter parameters in the I/O screen:
1. Press the Next or Prev screen key to display the I/O screen.
I/O screen:
2. Enter values in the I/O screen, as appropriate.
The following table describes the parameters in the I/O screen.
I/O parameters:
Parameter Function
Initial States Defines the initial condition for each
of the four event switches. At the
beginning of each injection cycle,
each switch returns to the state
defined in this parameter.
Set separation method parameters
Value range
On
Off
Toggle (Toggle is a
one-time change of
state.)
Pulse (Pulse is a
single pulse with a
width defined in
the Param column
of the I/O Events
table.)
No Change
July 29, 2013, 715003794 Rev. B 163