Table of Contents
Advertisement
R
Programming Platform Flash PROM via USB
The on-board USB-JTAG circuitry also programs the Xilinx XCF04S serial Platform Flash
PROM. The steps provided in this section describe how to set up the PROM file and how
to download it to the board to ultimately program the FPGA.
Generating the FPGA Configuration Bitstream File
Before generating the PROM file, create the FPGA bitstream file. The FPGA provides an
output clock, CCLK, when loading itself from an external PROM. The FPGA's internal
CCLK oscillator always starts at its slowest setting, approximately 1.5 MHz. Most external
PROMs support a higher frequency. Increase the CCLK frequency as appropriate to reduce
the FPGA's configuration time. The Xilinx XCF04S Platform Flash supports a 25 MHz
CCLK frequency.
Right-click Generator Programming File in the Processes pane, as shown in
Figure
Spartan-3E Starter Kit Board User Guide
UG230 (v1.0) March 9, 2006
Programming the FPGA, CPLD, or Platform Flash PROM via USB
Figure 4-9: iMPACT Programming Succeeded, the FPGA's DONE Pin is High
4-10. Left-click Properties.
www.xilinx.com
UG230_c4_10_022406
31
Advertisement
Table of Contents
