Safety Notes For Connecting; Step 1: Connecting The Dsl And The Transmitter - Siemens SITRANS FC430 Operating Instructions Manual

Note
Output cables
If long cables are used in noisy environments, it is recommended to use screened cables.
Unprotected cable ends
Danger of explosion through unprotected cable ends in hazardous areas.
• Protect unused cable ends in accordance with IEC/EN 60079-14.
5.4

Safety notes for connecting

Use in hazardous locations
Before accessing the sensor terminal space and application terminal space check that:
● No explosion hazard exists
● A safe access permission certificate has been issued by plant operations management
● All connection leads are potential free
5.5

Step 1: Connecting the DSL and the transmitter

The following only applies to remote configurations.
Wiring DSL (sensor) and transmitter (M12)
The DSL is provided with a preformed cable terminated with M12 style stainless steel
weather-proof plugs.
FC430 with HART
Operating Instructions, 05/2015, A5E03361511-AF
WARNING
WARNING
Hazardous locations
Observe the type examination certificates or the test certifications applicable in your
country if you use transmitters as category 1/2 equipment.
WARNING
Commissioning
Only apply power and commission the device after the device has been properly
connected and, if required, closed.
Connecting
5.4 Safety notes for connecting
57